|Place of Origin:||China|
|Minimum Order Quantity:||1 set|
|Packaging Details:||PE bag+ carton|
|Delivery Time:||5-10 days|
|Product Name:||Brushless Dc Motor Driver Board||Working Voltage:||12V-36VDC|
|Max Current:||15A||Working Current:||15A|
|PWM Speed Control:||PWM Frequency:1-20KHz,Duty Cycle 0-100%||Analog Voltage Speed Regulation:||0-5v|
|Brushless:||For Sensorless Brushless Dc Motor||Technical Support:||Yes|
|Color:||Blue||Speed Pulse Signal Output:||Yes|
36V15A motor drive controller,
12V15A stepper motor driver,
V8.3E motor drive controller
|· PWM speed control||PWM frequency:1-20KHZ; Duty cycle 0-100%|
|Analog voltage speed regulation||0-5V|
|O.V / L.V protection||YES|
|Speed pulse signal output||YES|
JYQD_V8.3E driver board is bare board without housing and heatsink. If the power of the motor below 60W ,it does not need to add heatsink, It only needs to ensure normal ventilation and well insulation. If the power of the motor more than 60W, it must add heatsink like the diagram as below.
Please take note that JYQD_V8.3E driver board has no anti-reverse connection protection, it will permanently damage the driver board if reversed polarity connection.
The 5V output port on the driver board prohibits connect external device. It is only applicable to the external potentiometer and switch of the board for speed regulation and reversal.
The “M” terminal on the JYQD_V8.3E driver board is the motor speed pulse output signal (push-pull output), and the maximum output current is less than 5mA.
5V -----Driver board internal output voltage
M ---- Motor speed pulse signal output port, 5V pulse signal.
1. Control port
Z/F---- Rotating direction control ports. Connect “5V” high level or no connect is Forward direction, connect 0 V low level or connect to GND is reverse direction.
VR ----Speed control port. Analog voltage linear speed regulation 0.1v -5V, The input resistance is 20K Ohm ,connect with GND when input PWM speed regulation, PWM frequency:1-20KHZ; Duty cycle 0-100%
GND—Used for Drive board internal control
2. Power port
MA ----motor phase A
MB ---- motor phase B
MC---- motor phase C
3. Use shielded wires if the drivers board has more than 50 cm distance from the motor, otherwise it may lead to abnormal driving, affecting the normal use.
4.Control port distance: 2.54mm,Power port distance:3.96 mm
5. Pay attention to the insulation between the driver MOSFET and the heatsink or the installation plate.
We can supply extra assy as connector wires and heatsink.
Contact Person: Ivanzhu